Products >Concrete Restoration & Repair Mortars >Mortars & Restoration Plasters >ASOCRET-M30

ASOCRET-M30

Repair and levelling mortar up to 30 mm for wall and floor areas

Properties:

  • For interior and exterior areas
  • Shrinkage compensated
  • Rapid setting
  • Water-repellent
  • Sulfate resistant
  • For thicknesses from 3 to 30 mm.
  • Very smooth application
  • High slump resistance
  • Can be quickly overcoated

Areas of Application:

ASOCRET-M30 is used for repairing and levelling of damage and voids in wall and floor areas up to a thickness of 30 mm in one application. It is also suitable for producing mineral-based fillets, water impermeable render coats with negative waterproofing (barrier render) from 10 mm thickness. Furthermore, ASOCRET-M30 can be used to level pool tank walls as well as for shaping other wall and floor areas up to 30 mm such as for example pool edge details or similar in swimming pool applications.

Storage:

dry, 12 months in the original unopened packaging. Use opened packaging promptly.

Technical Data:

  • Basis: Sand, cement, high quality additives
  • Colour: light grey
  • Water demand: approx. 4.50–5.25 l / 25 kg
    approx. 1.10–1.30 l / 6 kg approx
  • Bulk density: Substrate/1.6 kg/dm3
  • Packaging: 6 and 25 kg plastic bag
  • coved fillets: approx. 3.0 kg/m
  • Surface levelling: approx. 1.4 kg/m2/mm thickness

Product Details

Product Application:

Dependent on the desired consistency

Dependent on the desired consistency, place approx. 4.2 – 5.25 litres of clean water into a clean mixing bucket and whilst continuously mechanically stirring (mixing drill approx. 300 – 700 rpm), mix in as much dry mortar until a lump free, non-slump, smooth mortar paste is achieved. The mixing time is approx. 2–3 minutes. Allow to stand for 5 minutes then mix through once again. Application of the mortar is carried out to the technical regulations for plastering.

Product Levelling:

Surface levelling

ASOCRET-M30 can be applied to surfaces up to 30 mm in thickness in one application. Firstly apply a scratch coat of ASOCRET-M30 to the prepared substrate then apply to the desired thickness. Striking off is carried out dependent on the application using suitable tools (float, trowel or plasterer’s darby) within the working time. After the appropriate standing time, the surface can be rubbed down using a rubbing board, felt board or sponge board.